Ball joints on a vehicle equipped with MacPherson struts are being inspected for wear. Which of the following would be the correct method to check the load bearing joint?

Question 2 options:

Leave the vehicle weight on the tires, turn the steering wheel and listen for a popping noise.

Raise the vehicle by the subframe and measure the joints vertical movement.

Raise the vehicle by the lower control arm and measure the joints vertical movement.

Raise the vehicle by the subframe and turn the steering wheel and listen for a popping noise.

Question

28-03-2020
Engineering

contestada

Ball joints on a vehicle equipped with MacPherson struts are being inspected for wear. Which of the following would be the correct method to check the load bearing joint?

Question 2 options:

Leave the vehicle weight on the tires, turn the steering wheel and listen for a popping noise.

Raise the vehicle by the subframe and measure the joints vertical movement.

Raise the vehicle by the lower control arm and measure the joints vertical movement.

Raise the vehicle by the subframe and turn the steering wheel and listen for a popping noise.

Respuesta :

Otras preguntas

I MET a traveller from an antique land Who said: Two vast and trunkless legs of stone Stand in the desert ... Near them, on the sand, Half sunk, a shattered vi

1. Using two to three sentences, summarize what you investigated and observed in this lab. 2. What building material did you use to build your house? Did your

Match each concept with its key characteristic. 1. subset of a group survey population 2. equally favors all members of a group 3. collects data on members of a

On a straight road (taken to be in the +x direction) you drive for an hour at 50 km per hour, then quickly speed up to 90 km per hour and drive for an additiona

Dr. Blehert took 117 healthy bats into his laboratory. He exposed 83 of them to the fungus suspected of causing white-nose syndrome (WNS) while the rest of the

23. A passenger elevator travels from the first floor to the 60th floor, a distance of 210m, in 35s. What is the elevator’s speed? 24. A motorcycle is moving at

If a light wave is reflected with a 27° angle of reflection, what was the angle of incidence of which it was transmitted?a.117°b.153°c.27°d.63°

The written agreement between a corporation and its bondholders might contain a prohibition against paying dividends in excess of current earnings. This prohibi

The free length of the spring that is attached to the 0.3-lb slider is 3 in. If the slider is released from rest when x = 6 in., calculate its initial accelerat

Quantum mechanics is used to describe the vibrational motion of molecules, but analysis using classical physics gives some useful insight. In a classical model

monica789412 monica789412 · Answer 1 · 2020-04-05T21:22:07+02:00

he following would be the correct method to check the load bearing joint is Raise the vehicle by the subframe and turn the steering wheel and listen for a popping noise.

Explanation:

Ball joints on a vehicle equipped with MacPherson struts are being inspected for wear. It can be checked by raising the vehicle by the subframe and turn the steering wheel and listen for a popping noise.

When a joint of CV becomes rusted or damaged, the flexibility of axle becomes out of order and starts making a constant clicking noise whenever the wheels are turned around.

The struts are the most important part of the suspension system.

The metallic clunking noise is found to be one of the most noticeable and frequent symptoms that shows of a bad ball joint which gives a bad clunking or knocking noise whenever the suspension operates in an up and down motion.

The ball joint can be broken in the following ways:
the ball detaching from the socket and stud breakage, nonetheless of the type of breakage, but it is catastrophic.
When the joint of the ball completely breaks down, the wheel becomes free to move in all the directions.